Search results for "RC circuit"
showing 3 items of 3 documents
Current-Sensing Technique for Current-Mode Controlled Voltage Regulator Modules
2008
This paper introduces an innovative current-sense technique for voltage regulator modules (VRMs). The proposed method is applied to a multiphase buck converter although the converter topology does not affect the accuracy or effectiveness of the proposed technique. A RC network is parallel connected with the buck converter low-side MOSFET and the voltage signal across the sense capacitor reconstructs the inductor current waveform. The RC technique benefits from all the advantages of the most popular current-sensing technique, the inductor DC resistance current-sense method, cutting off its main disadvantage. The sense network design is oriented to obtain high immunity to noise and a great dy…
A lossless current sensing technique for flyback converters
2009
Regardless of the feedback control, almost all converters require input or output current sense for overcurrent protection. If a current mode control is implemented, high accuracy is also required. The optimal current sensing method shows the highest accuracy and the lowest power dissipation. In this paper, a lossless and accurate current sensing technique for Flyback converters is proposed. An RC network is parallel connected with the primary MOSFET and the voltage signal across the sense capacitor accurately reproduces the magnetizing current waveform. The RC technique benefits from all the advantages of the most common current sensing techniques currently applied to Flyback converters, a…
Phase Margin Degradation of a Peak Current Controlled Converter at Reduced Duty Cycle
2010
An inner current loop is frequently used in many switching power supplies to achieve higher stability and a good current sharing. Nevertheless, some problems derived from its practical implementation can be encountered. One problem is related to the need of filtering of the sensed current and was discovered by the authors in the implementation of a 500 W converter, when peak current control was applied by sensing the switch current. This paper will demonstrate mathematically that an RC filter not only filters out the noise but also can cause a degradation of the phase margin, especially, if the needed duty cycle is close to zero. The main reason for it is the severe distortion of the curren…